How To Use An Army Compass

Ensure that the dial is moving freely. Put your thumb into the thumb loop which is located on the side of the compass.


Video How To Use A Lensatic Compass U S Army 1966 Recoil Offgrid

You must make sure that the dial is floating properly.

How to use an army compass. Lensatic compasses have a bezel which rotates around its dial. With the cover opened up to 90 degrees and the reading lens opened to 45 degrees fold the thumb hook to its fully opened position. How do you use a sighting compass.

How to Use a Lensatic Compass. This particular model has been in service for many years which. After you have shot the azimuth you should slowly rotate the bezel to ensure it aligns with and lies directly in line with the.

Now its time to take out the map. Unser Military compass how to use Test hat erkannt dass die Qualität des getesteten Testsiegers in der Analyse extrem herausgeragt hat. Start spinning the bezel slowly until the magnetized needle is aligned with the orienting arrow Check the index line to find out the bearing you just have taken.

Position the compass approximately halfway between the chin and the belt keeping the North arrow under the Luminous Bezel Indicator. Now hold your compass horizontally and point the direction-of-travel-arrow towards the landmark. Then fold the rear sight slightly forward.

Then glance down at the dial through the eye lens to read the azimuth. To Take a Bearing Grasp the compass with your preferred grip. Let the compass rest on your thumb and index finger.

There are marks painted or etched on the dial. The base is the compass dial bezel and the thumb loopthe thumb loop is used for stability to garner a more accurate reading. Open the compass by folding down the thumb loop and opening the front cover until it is flat with the base of the compass.

Look through the rear-sight slot and align the front-sight hairline with the desired object in the distance. Once you have shot the azimuth using a lensatic compass the next thing of how to use a military compass is to set a course. Hold the compass correctly.

Zusätzlich das Preisschild ist im Bezug auf die gebotene Leistung überaus zufriedenstellend. This is where the term lensatic comes from. Compass and the remaining fingers around the fingers of the other hand.

Raise the rear sight until it is perpendicular to the base. Lastly the reading lens also helps cover the compass and folds out. Auch Fazits von anderen.

Use the sighting notch to align the compass with the target. These instruments are used by many military and armies around the world including the British Army. Read our most definite step of using a Lensatic military compass.

Using the Compass-to-Cheek Technique. To see if the needle is well leveled look closely at the needle and tilt it slightly to see if the needle is swaying side. Lift the compass and make sure it is at your eye level.

How to Use a Military Compass and Set a Course. If youre consulting a map place the map on a flat surface and place the compass. Open the compass cover at a 90-degree angle and then set the lens bracket at a 30-degree angle.

Fold the cover of the compass containing the sighting wire to a vertical position. This is the proper compass stance when traveling. Tolerance is - 3 Step Action 1 Note the calibration point azimuth.

With your course determined hold the lensatic compass open and level in both hands with the index finger of the right hand along the side of the compass. We think that some of the steps to using the Lensatic military compass will be easier if you know. How do you hold a military compass.

After you open the compass it will be at 90-degree angle and lens bracket in a 30-degree angle. Place your thumb inside the thumb hook and grasp the compass with a grip as shown above. Hold the compass level with the mirror at about a 45 angle.

This will place the compass between your chin and your belt. Francis Barker Liquid Prismatic Compasses. So What Compass Does The British Army Use.

When you decide to buy a compass you must know how to use a military compass. A compass should be laid down on a level surface so that the needle only rests or hangs on the bearing fused to the compass casing if used at a tilt the needle might touch the casing on the compass and not move freely hence not pointing to the magnetic north accurately giving a faulty reading. The cover is used to protect the compass and also incorporates the sighting wirewhich helps you determine direction.

When it comes to high grade compasses that are built for use in the field Francis Baker compassess are the holy grail. You will see that there is a sighting wire and sighting groove on the lens bracket. Pull your elbows firmly into Pull your elbows firmly into your sides.

Hold the compass by placing your thumb through the thumb loop and extending the index finger along the side of the base. The known magnetic azimuth from the calibration point to a designated point. Looking into the mirror turn the dial to align the orienting arrow with the north needle.

Compass calibration is described in the table below. Place the compass flat on your palm and your palm in front of your chest. 2 Shoot an azimuth from the calibration point to the designated point using the compass-to-cheek technique described in detail in this handout.

Wer viel Zeit in die Analyse auslassen will sollte sich an die Empfehlung aus dem Military compass how to use Vergleich orientieren. Turn the dial to align the orienting arrow with the north arrow.


Using A Lensatic Compass


How To Use A Lensatic Military Compass Navigate Safely In The Wild